View Full Version : Removing Crane Stock, how?
07-24-2006, 02:17 PM
I just got my G&P CQBR in and there are no directions that tell you how to take off the crane stock, so how do you do it?
07-24-2006, 02:23 PM
Dur, nevermind, found out. I also found out the inside of the stock is sharp, sliced my finger pretty good.
07-24-2006, 03:00 PM
Alright, next thing.
I have a sling adapter I need to put on, how do I remove the stock tube?
07-24-2006, 04:05 PM
When you take your stock off, take the stock plate off the back with an allen key on the bottom. Than take a screw driver (phillips) and stick it down the tube and unscrew the long screw that scews into the gear box, than it should just slide right off.
Thats all i know how to do lol, wish i could install a crane stock, im not that skilled.
07-24-2006, 04:24 PM
Be prepared to file a notch for the wires to feed through too.
07-24-2006, 05:06 PM
Nah, they feed fine, figured it out :P.
There's already a notch for the wires in the tube and they're not being squished too much, plus the part came with it so it should be fine.
07-24-2006, 05:45 PM
Come to my house and install a crane stock for me.
07-24-2006, 10:19 PM
As far as I know Milla, after you take off your stock M4 stock, just put on the Crane just like you would if you attached the stock M4 stock tube on.
But I don't know much about Cranes, I like the stock M4 stock. (Wow I said that too much).
07-25-2006, 12:23 AM
No, i mean have the battery in there to, which would mean rewiring the gearbox.
07-25-2006, 03:04 AM
What is wrong with your Vltor Milla?
Want to sell it?????
07-25-2006, 03:06 AM
not quite :-P
I just dont like the PEQ box, but if i do get a working crane stock, i will have to sell my vltor.
Powered by vBulletin® Version 4.2.0 Copyright © 2013 vBulletin Solutions, Inc. All rights reserved.