Removing Crane Stock, how?
I just got my G&P CQBR in and there are no directions that tell you how to take off the crane stock, so how do you do it?
Dur, nevermind, found out. I also found out the inside of the stock is sharp, sliced my finger pretty good.
Alright, next thing.
I have a sling adapter I need to put on, how do I remove the stock tube?
When you take your stock off, take the stock plate off the back with an allen key on the bottom. Than take a screw driver (phillips) and stick it down the tube and unscrew the long screw that scews into the gear box, than it should just slide right off.
Thats all i know how to do lol, wish i could install a crane stock, im not that skilled.
Be prepared to file a notch for the wires to feed through too.
Nah, they feed fine, figured it out :P.
There's already a notch for the wires in the tube and they're not being squished too much, plus the part came with it so it should be fine.
Come to my house and install a crane stock for me.
As far as I know Milla, after you take off your stock M4 stock, just put on the Crane just like you would if you attached the stock M4 stock tube on.
But I don't know much about Cranes, I like the stock M4 stock. (Wow I said that too much).
No, i mean have the battery in there to, which would mean rewiring the gearbox.
What is wrong with your Vltor Milla?
Want to sell it?????
I just dont like the PEQ box, but if i do get a working crane stock, i will have to sell my vltor.