Removing Crane Stock, how?

[Wilco]

I just got my G&P CQBR in and there are no directions that tell you how to take off the crane stock, so how do you do it?

[Wilco]

Dur, nevermind, found out. I also found out the inside of the stock is sharp, sliced my finger pretty good.

[Wilco]

Alright, next thing.

I have a sling adapter I need to put on, how do I remove the stock tube?

[Milla]

When you take your stock off, take the stock plate off the back with an allen key on the bottom. Than take a screw driver (phillips) and stick it down the tube and unscrew the long screw that scews into the gear box, than it should just slide right off.

Thats all i know how to do lol, wish i could install a crane stock, im not that skilled.

[Firefly26]

Be prepared to file a notch for the wires to feed through too.

[Wilco]

Nah, they feed fine, figured it out :P.

There's already a notch for the wires in the tube and they're not being squished too much, plus the part came with it so it should be fine.

[Milla]

Come to my house and install a crane stock for me.

[noah`]

As far as I know Milla, after you take off your stock M4 stock, just put on the Crane just like you would if you attached the stock M4 stock tube on.

But I don't know much about Cranes, I like the stock M4 stock. (Wow I said that too much).

[Milla]

No, i mean have the battery in there to, which would mean rewiring the gearbox.

[THE JACKAL]

What is wrong with your Vltor Milla?

Want to sell it?????

[Milla]

not quite

I just dont like the PEQ box, but if i do get a working crane stock, i will have to sell my vltor.